國內的點膠設備的不足主要表現在哪些方面？
國內點膠機設備普遍存在哪些不足？
What are the shortcomings of dispensing machine in China?
1.點膠機的內部散熱系統不是很好；
1. The internal cooling system of dispensing machine is not very good;
2.飲水機的機器經常有碰撞現象；
2. The machines of the water dispenser often collide;
3.液晶防黑，會出現亂碼；
3. The liquid crystal is black proof, and there will be disorder code;
4.一段時間運行后，會出現點膠機設備的位置偏差；
4. After a period of operation, there will be position deviation of dispensing machine equipment;
5.靜電處理不理想，分配器工作時會產生大量靜電；
5. The electrostatic treatment is not ideal, and a large amount of static electricity will be generated when the distributor works;
6，特別是三軸點膠機，運行速度慢；
6, especially the three-axis dispensing machine, the running speed is slow;
7.點膠設備將在正常運行的情況下出現；
7. Dispensing equipment will appear under normal operation;
8.Table與小型分配器一起使用一段時間。 表的繼電器將損壞，導致信號在輸出處泄漏。
8. Table is used with small distributor for a period of time. The relay of the meter will be damaged, causing the signal to leak at the output.
9. CF卡程序不夠穩定。 工業計算機經常燒壞。
9. The CF card program is not stable. Industrial computers often burn out.
10.點膠機的承載能力較弱；
10. The loading capacity of dispensing machine is weak;
11.驅動器板連接器的連接松動，很容易導致主板與驅動器板之間的接觸不良。
11. The connector of the drive board is loose, which is easy to cause poor contact between the main board and the drive board.
以上是點膠機設備的一些缺陷，以確保點膠機機械設備的，穩定和精確的點膠。
The above are some defects of dispensing machine equipment in China to ensure the efficient, stable and accurate dispensing of dispensing machine machinery and equipment.
上一篇：點膠機運行過程中常存在哪些缺陷？
下一篇：雙組份打膠機在企業中起什么作用？
